Lenovo 7D9F Manual page 153

• FQXSPTR4003I: Synchronize time setting by user [arg1]: Mode=Sync with server clock.
A user configured the Date and Time synchronize settings
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0224
User Action:
Information only; no action is required.
• FQXSPUN0009G: Sensor [SensorElementName] has asserted.
This message is for the use case when an implementation has detected a Sensor has asserted.
Severity: Warning
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0508
User Action:
Complete the following steps until the problem is solved:
1. Try to access the XCC by original IP. If networking does not have response, try to access the XCC by
default IP directly through dedicated XCC management port. If none of the above external IP worked,
try the in band IP: 169.254.95.120 with lanoverusb enabled in OS.
2. If XCC is accessible by the following the item#1, update the XCC both primary/2nd bank FW.
3. If XCC is not accessible, reboot the system.
4. Press F1 or use LXPM to do XCC firmware update.
5. If the problem still exists, contact Lenovo Support for RoT security module replacement.
• FQXSPUN0009I: Sensor [SensorElementName] has asserted.
This message is for the use case when an implementation has detected a Sensor has asserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0508
User Action:
Complete the following steps until the problem is solved:
1. If the server is constantly rebooting, perform a virtual reseat or A/C cycle on the server.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSPUN0010I: Sensor [SensorElementName] has deasserted.
This message is for the use case when an implementation has detected a Sensor has deasserted.
Severity: Info
.
Chapter 2 XClarity Controller events
149