Lenovo 7D9F Manual page 28

Messages and codes reference
Hide thumbs Also See for 7D9F:
Table of Contents

Advertisement

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPUN2023I
Sensor [SensorElementName] has deasserted the transition to non-
recoverable.
FQXSPUN2026I
Device [LogicalDeviceElementName] has been removed from unit
[PhysicalPackageElementName].
FQXSPUN2027I
Device [LogicalDeviceElementName] has been added.
FQXSPUN2049I
The RAID controller in PCI slot [arg1] is no longer in warning status.
FQXSPUN2050I
The RAID controller in PCI slot [arg1] is no longer in critical status.
FQXSPUN2058I
The remaining life for all SSDs is above threshold [arg1].
FQXSPUP0001I
A firmware or software change occurred on system
[ComputerSystemElementName].
FQXSPUP0002I
A firmware or software change occurred on system
[ComputerSystemElementName].
FQXSPUP0003I
A firmware or software change occurred on system
[ComputerSystemElementName].
FQXSPUP2007I
Valid and Supported firmware or software was detected on system
[ComputerSystemElementName].
FQXSPUP4001I
Flash of [arg1] from [arg2] succeeded for user [arg3] .
FQXSPUP4002I
Flash of [arg1] from [arg2] failed for user [arg3].
FQXSPUP4006I
Auto promote primary XCC to backup is [arg1] by user [arg2] from
[arg3] at IP address [arg4].
FQXSPUP4007I
Violation access to XCC SPI flash is detected and isolated.
FQXSPUP4008I
Violation access to UEFI SPI flash is detected and isolated.
FQXSPWD0000I
Watchdog Timer expired for [WatchdogElementName].
FQXSPWD0001I
Reboot of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0002I
Powering off system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0003I
Power cycle of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0004I
Watchdog Timer interrupt occurred for [WatchdogElementName].
FQXSPBR4001I
Running the backup Management Controller [arg1] main application.
FQXSPCA0007J
Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has asserted.
FQXSPDM4002I
Device [arg1] VPD is not valid.
FQXSPEA0001J
Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPIO0014J
Bus [SensorElementName] is operating in a degraded state.
FQXSPIO2000J
The connector [PhysicalConnectorElementName] has been
disconnected.
24
ThinkSystem SR655 V3 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Warning
Warning
Warning
Warning
Warning
Warning

Advertisement

Table of Contents
loading

This manual is also suitable for:

7d9eThinksystem sr655 v3

Table of Contents