Lenovo 7D9F Manual page 37

CIM Prefix: IMM CIM ID: 0272
User Action:
Information only; no action is required.
• FQXSPBT0007I: No bootable media available for system [ComputerSystemElementName].
This message is for the use case when an implementation has detected a System with No Bootable
Media.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0286
User Action:
Complete the following steps until the problem is solved:
1. Review PD Steps.
2. Check the Hard drive type is within system support configuration.
3. Make sure the bootable media is installed correctly.
4. Make sure UEFI boot mode is set correctly.
5. Make sure the boot device is set within UEFI boot sequence.
6. If problem persists, escalate to next level of support.
• FQXSPCA0002M: Numeric sensor [NumericSensorElementName] going low (lower critical) has
asserted.
This message is for the use case when an implementation has detected a Lower Critical sensor going low
has asserted.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Fan Failure
SNMP Trap ID: 11
CIM Prefix: PLAT CIM ID: 0480
User Action:
Complete the following steps until the problem is solved:
1. Reseat the failed fan reported.
2. Install the fan into another known good fan slot to see if the issue is resolved.
3. If the problem persists, collect service data log from the XCC WebGUI and replace the fan.
4. Contact Lenovo Support.
• FQXSPCA0007J: Numeric sensor [NumericSensorElementName] going high (upper non-critical)
has asserted.
This message is for the use case when an implementation has detected an Upper Non-critical sensor
going high has asserted.
Severity: Warning
Serviceable: Yes
.
Chapter 2 XClarity Controller events
33