Advertisement
Select a subtest from the menu and press Enter . The following messages appear:
5.
TEST LOOP
ERROR STOP
Use arrow keys to move the cursor to an option and press Enter .
Selecting YES for TEST LOOP sets the test to run until halted by the user. Select-
ing NO exits to the main menu after the test is complete.
Selecting YES for ERROR STOP stops the test when an error is found and dis-
plays the operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME
These three selections have the following functions:
1: Terminates test and exits to subtest menu.
2: Continues test.
3: Restarts test from the beginning.
Use arrow keys to move the cursor to an option and press Enter .
Selecting NO for ERROR STOP keeps a test running even if an error is found.
Table 3-1 in section 3.3 describes each subtest menu test function; Table 3-3 in section 3.14
lists codes and status for each error.
T4700CS, T4700CT, T4800CT
: YES
: YES
[[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
3-5
Advertisement
