Advertisement
Installing the Display Assembly
To install the T4700CS/T4700CT/T4800CT's display assembly, follow the steps below and
refer to figures 4-21 through 4-24.
1.
Place the display assembly on the computer making sure the brackets on the
display fit in front of the corresponding brackets on the computer.
2.
Hold the display to steady it and secure the three M2.5x6 screws for the display
hinges to secure the display assembly (figure 4-24). Secure the screw for the
display hinge brace at the right side of the computer first, then secure the screws at
the corners.
3.
Turn the computer around and secure the two M2.5x6 silver screws on the back
(figure 4-23).
4.
Turn the computer again so the front faces you and connect the display sensor
switch cable to PJ5 on the upper system board, then secure it with tape (figure 4-
21).
5.
Connect the display cables to PJ3 and FL cable to PJ2 on the upper system
board (figure 4-22).
6.
Secure the ground cable with one M2.5x6 screw to the upper system board
(figure 4-22).
7.
Install the top cover, HDD pack, optional PCMCIA card, optional memory card,
and battery pack as described in sections 4.6, 4.5, 4.4, 4.3 and 4.2.
T4700CS, T4700CT, T4800CT
4-25
Advertisement
