Advertisement
Installing the Speaker, RTC Battery, BPQP port
To install the T4700CS/T4700CT/T4800CT's speaker, RTC battery, and BPQP port, follow
the steps below and refer to figures 4-36 through 4-38.
1.
Connect the speaker, RTC battery, and BPQP port cable to PCMCIA slot 1
board (figure 4-38).
2.
Seat the PCMCIA slot 2 board with speaker, RTC battery, and BPQP port
attached, then connect the two PCMCIA slot 2 connectors to the lower system
board (figure 4-37).
3.
Secure the PCMCIA slot 2 board with two M2x6 screws, then set the speaker,
RTC battery and BPQP port in place. Make sure insulation for the speaker cables
goes on top of the cables (figure 4-37).
4.
Fit the right side of the speaker's metal cover into the latches on the base assem-
bly and secure the cover with two M2.5x6 screws (figure 4-36).
5.
Secure the BPQP with two M2.5x6 screws.
6.
Install the base assembly, power supply board, upper system board, display assem-
bly, backup battery and microphone, status indicator panel, keyboard, top cover,
HDD, optional PCMCIA cards, optional memory card and battery pack as de-
scribed in sections 4.12, 4.11, 4.10, 4.9, 4.8, 4.7, 4.6, 4.5, 4.4, 4.3 and 4.2.
4 - 3 8
T4700CS, T4700CT, T4800CT
Advertisement
