Advertisement
Procedure 2
Message Check
When the T4700CS/T4700CT/T4800CT's HDD does not function properly, some of the
following error messages may appear on the display. Start with Check 1 below and perform
the other checks as instructed.
Check 1
If any of the following messages appear, perform Check 2. If the following mes-
sages do not appear, perform Check 4:
HDC ERROR
(After 5 seconds this message will disappear.)
HDD #0 ERROR
(After 5 seconds this message will disappear.)
HDD #1 ERROR
(After 5 seconds this message will disappear.)
Check 2
If either of the following messages appears, perform Procedure 3. If the following
messages do not appear, perform Check 3.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key
Check 3
Using the Toshiba MS-DOS system disk, install a system program on the hard disk
using the SYS command.
If the following message appears on the display, the system program has been
transferred to the HDD. Restart the T4700CS/T4700CT/T4800CT. If the error
message still appears, perform Procedure 3.
System transferred
T4700CS, T4700CT, T4800CT
or
or
or
2-27
Advertisement
