Advertisement
Installing the Base Assembly
To install the T4700CS/T4700CT/T4800CT's base assembly and power/reset board, follow
the steps below and refer to figures 4-28 through 4-32.
1.
Connect the power/reset cable to the power/reset board (figure 4-31).
2.
Seat the power/reset board inside its brackets on the bottom cover, then fold the
power/reset cable down into the slot in front of the system board. Leave about 2
cm extending out of the slot (figure 4-32).
3.
Fit the I/O port connector side of the base assembly into the bottom cover. Then,
make sure the power/reset cable extends through the notch on the base assembly
and lay the base assembly into the bottom cover. Press the FDD eject button so
the base assembly can clear the bottom cover (figure 4-30).
4.
Secure the base assembly's front-left corner with one M2.5x6 screw (figure 4-30).
5.
Secure the two M2.5x6 silver screws and one M2.5x12 silver screw on the
bottom cover (figure 4-29).
6.
Secure the PCMCIA slot 2 cover with one M2.5x4 silver screw and close the
slot cover (figure 4-28).
7.
Install the power supply board, upper system board, display assembly, backup
battery and microphone, status indicator panel, keyboard, top cover, HDD, op-
tional PCMCIA card, optional memory card and battery pack as described in
sections 4.11, 4.10, 4.9, 4.8, 4.7, 4.6, 4.5, 4.4, 4.3 and 4.2.
4 - 3 2
Figure 4-32 Power/reset cable setting
T4700CS, T4700CT, T4800CT
Advertisement
