Advertisement
5.
Remove the two M2.5x6 screws, securing the display hinge and one M2.5x6
screw securing the ground cable (figure 4-49).
6.
Remove the display hinge and lift off the display cable (figure 4-49).
Figure 4-49 Removing the display cables (T4700CS)
Installing the FL Inverter Cable, Display Cable
To install the T4700CS's FL inverter cable, display cable, follow the steps below and refer to
figures 4-48 and 4-49.
1.
Fit the display cable to the display cover and secure the display hinge with two
M2.5x6 screws. Secure the ground cable to the display cover with one M2.5x6
screw (figure 4-49).
2.
Connect the FL inverter cable to PJ2 of the upper system board, and secure it
with tape to the display cover (figure 4-48).
.
3.
Install the FL, LCD module, FL inverter board, display mask, top cover, and
battery pack as described in sections 4.2, 4.6, 4.16, 4.17, 4.18 and 4.19.
4-52
T4700CS, T4700CT, T4800CT
Advertisement
