Hisense YXE-A03U Technical & Service Manual page 91

3. Central Controller(YJE-C01T(E))
3. Timer OFF setting can be performed in the same procedure
with timer ON setting.
4. After TIMER ON/OFF setting is completed, press "
(plus) or " ''(minus) to select desired day, press
"ENTER" button to confirm it, or press "CANCEL" button to
cancel. The selected day will be marked with ".".
For example,
selected are effective.
5. After the setting of seven days a week is completed, proceed
to the setting for group 2, which can be performed in the
same setting procedure as group l. Four groups can be set
at most.
6 You can quit WEEKLY TIMER setting by pressing "TIMER/
CLOCK" or "ON/OFF" button in the group selection mode.
Checking the current weekly timer setting
Press "TIMER/CLOCK" button to check WEEKLY TIMER
setting in this mode.
Press " " (plus) or " " (minus) button to check the
previous or next set time.
You can press "TIMER/CLOCK" button under checking state
to quit checking of WEEKLY TIMER.
If you need to temporarily leave for a few days when weekly timer has been set, meanwhile timer
ON/OFF is not permitted to work and continue to work after you are back, you can hold down "ON/OFF"
button for 3 seconds to turn it off completely. At this moment, weekly timer set time can still be saved,
but air conditioner will not run. Weekly timer setting resolution is 1 minute. Timer ON/OFF signal is
effective within 1 minute.
Temperature Display Setting
Default display: set temperature
If you need to display room temperature, press "
"ENTER" button simultaneously for 3 seconds. Then the buzzer
beeps for 4 times indicating setting has been changed. Then
appears on the LCD, indicating that the temperature shown on
LCD is room temperature.
If you need to cancel setting, press "
button simultaneously for 3 seconds. Then
LCD, indicating that the temperature shown on LCD is the set
temperature.
Buzzer Indicator Selection
The buzzer beeps during operation by default. If you need mute
operation, hold down "FAN" button for 3 seconds, and the
buzzer beeps for 4 times indicating setting has been successfully
changed.
If you need to return to defaulted setting, repeat the steps above.
Backlight Selection
The backlight of the screen lights up during operation by default.
If you need to turn off the backlight, hold down "MODE" button
for 3 seconds and the buzzer beeps for 4 times indicating setting
has been successfully changed.
If you need to return to defaulted setting, repeat the steps above.
shows 7 days of a week all
" button and
" button and "ENTER"
disappears on the
89
"
Timer ON Setting
Timer OFF Setting
Timer Day Select
ADD. FUNC.
部
TIMER/CLOCK
件
介
CANCEL
绍
ADD. FUNC.
部
TIMER/CLOCK
件
介
CANCEL
绍
ADD. FUNC.
部
TIMER/CLOCK
件
介
CANCEL
绍
ON/OFF
SWING ENTER FAN MODE
ZONE
ON/OFF
MODE
SWING ENTER FAN
ZONE
ON/OFF
MODE
SWING ENTER FAN
ZONE