Hisense YXE-A03U Technical & Service Manual page 55

2. Wired Controller(YXE-E01U(E)/YXE-E02U(E))
Wi-Fi setting
Press and hold the "
successfully, the Wi-Fi indicator "
means that the network setting is failed and needs to be reset.
Single TIMER ON
1. During OFF condition, press "
are flickering.
2. Press " " / " " button to adjust the time, the timing time flickers and the
icon " " appears. Each time "
increases/ decrease by 0.5h. It can be set from 0h to 24h, and timer setting
resolution is 0.5h.
3. Press the " " button again to confirm and exit.
After the settings are completed, the timing icon "
timer countdown will be displayed as per the minimum unit(0.5h).
How to cancel:
Press and hold the button "
NOTE:
(1) The fan speed/ LOU/ mode/ temperature still can be adjusted as required after settings are completed.
(2) If any change to time is necessary after the settings are completed, the procedures are the same as those of setting.
(3) The timing setting is unavailable in case of a failure.
(4) If timing operation of the indoor unit has been performed by another remote control, when the wired controller is
operated, the timing time can only be displayed and cannot be changed.
Single TIMER OFF
You can set TIMER OFF with the same method when the appliance is ON.
Health mode
How to activate
1. Press the " " button under ON state;
2. Press the " " / "
3. Press the " " button again to confirm the setting to enter health mode.
Repeat the operations mentioned above to select the "
the "ON/OFF", "Mode" to exit directly.
Energy-saving mode
Under the energy-saving mode, the air conditioner will run
more energy-saving.
How to activate:
1. Press the " " button under cooling/ heating/ drying state;
2. Press the " " / "
3. Press the " " button again to confirm the settings to inter into
into Energy saving mode.
How to cancel:
Repeat the operations mentioned above to select the "
the "ON/OFF", "Mode", "Fan speed", "Sleep" , "Mute" and "Temperature setting" mode to exit
directly.
NOTE:
Energy-saving function is invalid in dehumidification/ super cooling/ heating mode.
" and " " buttons for 3s to enter the Wi-Fi setting state. After setting
" will be displayed. If the Wi-Fi indicator is not displayed, it
" button until icon "
" / " " button is pressed, timer setting
" for 3s to exit.
" button to select " " icon, which will flicker then;
" button to select "
" and clock setting
" will appear and the
" icon, which will disappear then. Switch
" icon, which will flicker then;
" icon, which will disappear then. Switch
53
1,3
2
YXE-E01U(E)
1,3 2
YXE-E02U(E)
1,3
2
YXE-E01U(E)
2 1,3
YXE-E02U(E)
2 1,3
YXE-E01U(E)
1,3
2
YXE-E02U(E)