2. Wired Controller(YXE-C01U1(E))
Indoor Unit Parameter Setting
The internal parameters of the air conditioner can be set with the following method
Instruction
1. Hold down both MODE button and ADD. FUNC. button for 3s, symbol
blink at the same time. (See fig. 4)
2. Press
or
, and the parameter code increases or decreases by 1 accordingly. When 17 displays,
press ENTER button to rewrite the EE parameter of the indoor unit, at the same time, the symbol
lights and EE parameter code 00 blinks.(See fig.5)
3. Press
or
, and the EE parameter code increases or decreases by 1 accordingly and the
corresponding value of EE displays in the Timer display area. When the EE code needs to be rewritten
displays, press ENTER button to come to EE rewriting mode, at the same time the symbol
EE parameter code lights and the value of EE blinks. For the EE parameter code, see Table 2.
4. When the value of EE blinks, press
press TIMER/CLOCK button to save it. For example, the diagram above shows that when the
parameter code is 1 (Self-recovery of power break), the function of self-recovery of power break can
be realized.
5. Press ON/OFF button to quit to # 17, press ON/OFF button again to exit from the parameter
rewriting state.
确 定
fig. 4
or
to adjust it until the value needed displays, at this time,
1
2
确 定
fig. 5
27
.
and parameter number
确 定
1
fig. 5
lights,