Hisense YXE-A03U Technical & Service Manual page 24

2. Wired Controller(YXE-C01U1(E))
2. Timer ON hour flickers, press "
button) to select the desired time.
Each time " " button is pressed, time increases by 1h;
Each time " " button is pressed, time decreases by 1h.
Pressing and holding down the "
to increase continuously and rapidly.
After timer ON hour has been set, press "ENTER" button to
return to timer ON minute setting.
If you don't need Timer OFF setting, press "CANCEL" button to
cancel it.
3. Timer OFF setting is the same step with timer ON setting.
4. After TIMER ON/OFF setting is completed, press "
button)/ " " (minus button) to select desired day, press
"ENTER" button to confirm it, or press "CANCEL" button to
cancel it. The selected day will be marked with " ".
For example,
is effective.
5. Continue group 2 setting, repeat the same setting procedure as
group1. Four groups Timer ON/OFF can be set at most .
6. You can quit WEEKLY TIMER setting by pressing "TIMER/CLOCK"
or "ON/OFF" button when group number is flickering.
Weekly Timing Inquiry
When the weekly TIMER function is available, it will go into the weekly timing inquiry if you press the
"TIMER/CLOCK" button. Press the plus button "
timer moment.
NOTE:
If you need to temporarily leave for a few days when weekly timer has been set, meanwhile timer ON/OFF
is not permitted to work and continue to work after you are back, you can hold down "ON/OFF" button for
3 seconds to turn it off completely. At this moment, set time of the weekly timer can still be saved, but the air
conditioner will not run. Weekly timer setting resolution is 1 minute. Timer ON/OFF signal is effective within
1 minute.
Buzzer Indicator Selection
The buzzer beeps by default when the controller is operated.
If you need mute operation, hold down "FAN" button for 3 seconds,
the buzzer beeps for 4 times indicating the setting has been
successfully changed. Repeat the same steps to return to the original
setting.
Dimmer Setting
The screen is bright by default. If you want the screen to be dark,
hold down "MODE" button for 3 seconds, the buzzer beeps for 4
times indicating the setting has been successfully changed.
Repeat the steps above to return to the original setting.
"(plus button) or "
/ "button causes the value
shows any day of a week selected
" or minus button "
22
" (minus
Timer group select
" (plus
TIMER day select
" to inquire the previous or the next
TIMER ON set
TIMER OFF set