Hisense YXE-A03U Technical & Service Manual page 52

2. Wired Controller(YXE-E01U(E)/YXE-E02U(E))
Simple Operation
This wire controller should be used with the air conditioner. it can be used for cooling, heating, dry
and fan etc. For other functions and settings, please refer to the specific operation in this manual.
1. Turning ON/OFF
Press the " " button, the appliance will be started or stopped.
2. Mode setting
Press " " button to select operation mode.
Each time " " button is pressed, the operation mode will change in the following sequence:
COOL
NOTE:
AUTO mode is invalid for models without AUTO mode when setting. HEATING mode is invalid for cooling only types or
heating-forbidden air conditioners.
3. Temperature setting
Press the" " or "
Each time " " or "
COOLING, HEATING, DRY
FAN ONLY
NOTE:
(1) Heating mode is invalid for cooling-only air conditioners.
(2) The default setting range depends on the indoor unit, some models are 18~32℃, and some models are 20~28℃.
(3) Setting range can be changed by professional staff, and for detailed operations, please contact the installation servise/
after-sales service center.
(4) When the set temperature reaches the upper or lower limits setting temperature will not increase or decrease.
4. Fan speed setting
Press the " " button to adjust the fan speed. The fan speed will change in the following sequence:
LOW
NOTE:
(1) AUTO fan speed is invalid for "
(2) AUTO fan speed is the default setting under Dry mode, and it can't be adjusted.
DRY
" button to enter the temperature setting state.
" button is pressed, temperature setting increases/decreases by 0.5℉/0.5℃.
Temperature setting range
MEDIUM
" mode.
FAN
HEAT
16℃~ 30℃ (61℉~86℉)
Unavailable for setting
AUTO
HIGH
AUTO
50
AUTO