Hisense YXE-A03U Technical & Service Manual page 61

2. Wired Controller(YXE-E01U(E)/YXE-E02U(E))
Read the operating parameters of indoor unit
The internal parameters of the air conditioner can be set with the following method
Instruction
1. Press and hold the "
for 3s at the same time to enter the parameter
self-setting state, Then the "
icon will be always on.
2. Press the " " / "
or decrease the root address as 2.
3. Press the " " / "
decrease the sub-address, and select the desired
sub-address value.
4. Press the " " button to exit without settings.
The catalogue of custom-setting parameters is shown as follows:
Sub-address
parameter code
00 Slave unit model
01 Indoor unit model
02 Outdoor unit model
03 Program version number of indoor unit
04 Indoor unit capacity code
05 Program version number of outdoor unit
06 Return air temperature of indoor unit
07 Indoor unit coil temperature
08 Outdoor ambient temperature
09 Compressor exhaust temperature
10 Compressor return air temperature
11 Outdoor condenser temperature
12 Compressor discharge pressure
13 Compressor suction pressure
Outdoor unit electronic expansion valve
14
opening
15 AC input current
16 Effective value of AC voltage
17 Indoor unit built-in EE
18 Indoor unit external EE
19 Outdoor unit built-in EE
20 Outdoor unit external EE
21 Clock
22 Time-lapse function status
Wire controller sampling indoor ambient
23
temperature
24 Fault code
25 Drive board fault code
26 Air outlet temperature of indoor unit
Indoor unit electronic expansion valve
27
opening
28 Compressor current
29 Indoor unit body temperature
30 Inlet temperature of indoor unit coil
31 Outlet temperature of indoor unit coil
32 Inlet temperature of outdoor condenser
33 Outlet temperature of outdoor condenser
" and " " button
" and "
" button to increase
" button to increase or
Parameter description
"
sub-address+
root address+
3
root address- sub-address-
YXE-E01U(E)
Parameter
Parameter description
code
Indoor unit address
34
System address
35
Local indoor unit address
36
Outdoor unit operation mode
37
Number of outdoor units started
38
Number of indoor units started
39
Number of indoor units allocated during automatic
40
allocation
Target frequency
41
Driving frequency
42
Outdoor unit defrosting temperature
43
Target defrosting temperature
44
Water inlet temperature of water module
45
Water outlet temperature of water module
46
Temperature after indoor electric heating
47
Inlet temperature of gas replenishment and enthalpy
48
increase
Outlet temperature of gas replenishment and enthalpy
49
increase
Inlet temperature of water heater
50
Outlet temperature of water heater
51
Water heater temperature1
52
Water heater temperature2
53
Computing power requirements
54
Target speed of fan1
55
Target speed of fan2
56
57 Actual speed of fan1
Actual speed of fan2
58
Indoor target speed
59
Indoor actual speed
60
Opening of air replenishment enthalpy increasing
61
valve
Indoor unit characteristic code
63
Registration code
64
Registration information
65
Network D information
66
59
.
Parameters value code
root address sub-address
root address+ sub-address+
1
root address- sub-address-
YXE-E02U(E)
1
3