Hisense YXE-A03U Technical & Service Manual page 58

2. Wired Controller(YXE-E01U(E)/YXE-E02U(E))
5. Wiring
Connect the controlling cable with upper cover terminal as the figure below.
Connect the attached controlling cable with indoor unit control board.
For details of the specific wiring terminals, please refer to wiring diagram of the indoor unit.
Note:
The connecting wires shall be secured firmly after connection. In order to prevent any water and insects from entering into the opening
where the wire is led into, the opening shall be practically sealed with putty(to be provided on the site).
6. Upper cover assembly
Align the upper cover with the hasp of lower cover of the wired controller, and then press the upper
cover onto the lower cover. After installation, tear off protective sticker attached on the display of
wired controller.
upper cover lower cover
Hasp
Hasp
56