Hisense YXE-A03U Technical & Service Manual page 18

2. Wired Controller(YXE-C01U1(E))
Simple Operation
This wired remote controller should be used with the air conditioner, and it can be used for cooling,
heating, drying and fan, etc. F
in this manual.
3
确 定
5
3
2. Mode Setting
Press "MODE" button to select modes.
Each time MODE button is pressed, the operation mode changes in sequence below:
COOLING
NOTE:
AUTO mode is invalid for models without AUTO mode when setting.
HEATING mode is invalid for cooling only types or heating-forbidden air conditioners.
3. Temperature Setting
Under ON conditions or under OFF conditions where TIMER ON function is enabled.
Press" " or "
" button to enter the temperature setting state.
Each time " " button is pressed, temperature setting rises by 1℉/1℃；
" button is pressed, temperature setting lowers by 1℉/1℃；
Each time"
HEATING, COOLING, DRY, AUTO
NOTE:
1) Heating mode is ineffective for COOLING ONLY models.
2) The default setting range depends on the indoor unit.
3) Setting range can be changed by professional stuff, please contact installation service when needed.
4) When setting temperature is above setting range,
not rise or lower any more.
4. Fan Speed Setting
Under ON conditions or under OFF conditions where TIMER ON function is enabled, press
the "FAN" button to adjust the fan speed. The fan speed will change in the following sequence:
LOW
or other functions and settings, please refer to the specific operation
1
2
4
DRY
FAN ONLY
Range of Temperature Setting
61℉~86℉(16℃~30℃)
Unavailable for setting
FAN ONLY
MEDIUM HIGH
1. Turning ON/OFF
<To start operation>
Press the ON/OFF button , the ON lamp lights up, and
the appliance will be started.
<To stop operation>
Press the ON/OFF button again, the ON lamp goes off,
and the appliance will be stopped.
Hold down "ON/OFF" button for more than 3 seconds, and
the appliance will enter completely shutdown state.
(When indoor unit stops, you cannot use Timer ON to start,
but start it manually), the buzzer beeps for 4 times.
HEATING AUTO
will display on the LCD, the set temperature will
AUTO
(The indicators will be lightened
circularly in the direction of arrow)
16