Hisense YXE-A03U Technical & Service Manual page 87

3. Central Controller(YJE-C01T(E))
5. SWING Setting
Press "SWING" button to select SWING in ON state, or in OFF state with timer set. Each time "SWING"
button is pressed, the SWING changes in the following sequence.
NOTE:
1. This setting is only effective for units with this Swing function.
2. is only available for specific models.
3. In "DRY" mode, the fan speed is set to "AUTO" automatically and "FAN" button is ineffective in this
case.
Function Setting
Clock
Date Clock Indicator of day
of week
2
ADD. FUNC.
ON/OFF
1
TIMER/CLOCK
SWING ENTER FAN
3
CANCEL
2
1. Clock correction should be set under complete shutoff state.
2. If there are two central controllers in the system, only the clock setting on the main central controller
is effective.
3. Complete shutoff: When the unit is turned on, holding down "ON/OFF" button for 3 seconds will
enter complete shutoff state.
Temporary shutoff: When the unit is turned on, press "ON/OFF" button to turn to temporary shutoff
state. Shutoff state in this manual all means temporary shutoff.
Button Locked
Up/Down Left/Right
SWING SWING
Using for the first time and clock loss caused by being unused for
a long time, setting clock of central controller is needed at first.
How to set:
1. Indicators of date and day of week all blink after turning on.
2. Press "
minute in sequence. Press "ENTER" to confirm.
Clock Correction
Hold down "TIMER/CLOCK" button for 3 seconds under complete
shutoff state to enter clock correction setting.
The settings of clock can be adjusted in the following sequence
and the same method as clock setting.
After the adjustment is completed, press "ENTER" button to
MODE
confirm the setting.
ZONE
After the clock has been set, the central controller will display the
current clock.
Button Locked
After central controller setting is finished, you can set button
locked function to avoid children or other people's wrong
operation.
All operations are invalid after button locked function has been
set. After locking, the central controller still can operate normally.
And unlocking can only be performed by the central controller.
How to set:
Hold down "ENTER" button for 3 seconds, the buzzer beeps for 4
times indicating the setting is successfully set and
on the LCD, indicating that the wired controller is now under the
button locked state.
No Display
Up/Down/Left/Right
Nothing
SWING
"and " " to set the current date, day of week, hour,
Year Month, Day days of week
85
hour, minute
is displayed