Hisense YXE-A03U Technical & Service Manual page 49

2. Wired Controller(YXE-C02U1(E))
4.Address Setting
It is used to set the address of wired remote controller
if there is central control.
Setting method:
1. Under OFF conditions and if there is no RTC
setting, you can press the " " button (plus) or " "
button (minus) to adjust till the wired remote controller
displays .
2. Hold down the "ADD. FUNC." button for 3s, the
buzzer will beep to alert that it goes into the
address setting state.
The LCD will show the address setting icon
address icon is flickering.
Press the " " button (plus) and " " button (minus)
to adjust the address, the address setting range is
1-128, and you can not adjust in excess of the
maximum controlled quantity for central control
setting.
3. Press the "ENTER" button to confirm the setting,
and then the address icon and address numerical
value icon will stop flickering, indicating that the
setting is completed.
5.DIP setting
Please set the DIP switch code based on the practical
situations, which will work if it is dialed before power on.
ON
OFF
16
NOTE: The symbol " " represents the position
where the DIP locates.
Dial Code Dial Content
After the fuse on electric control board blows,
Fuse short-circuit
SW16-1
you can dial the dial code to ON to restore
setting
the integrated control communication.
In order to guarantee the communication
Terminal resistance
SW16-2
speed, it must be set as ON if being at the
setting
both ends of integrated control system.
and
Setting Method
47