Hisense YXE-A03U Technical & Service Manual page 86

3. Central Controller(YJE-C01T(E))
Simple Operation
This central controller is used for unified cooling, heating, drying and air supply, etc. of the air conditioners
in the group/zone. For other functions and settings, please refer to the details on the setting of functions
in this manual.
3
确 定
5
3
1. The ON/OFF button of central controller is only used to change the ON/OFF state of the air
conditioners in the group/zone without affecting the other settings.
2. When the wired controller (if any) for the group/zone receives the shutdown command from the
central controller, the appliance will enter completely shutdown state.
2. Mode Setting
Press "MODE" button to select the desired operation mode in ON state, or OFF state with timer set.
Once the MODE button is pressed, the operation mode is changed in the sequence below:
COOLING
3. Temperature setting
Press " "or " " button to set the desired temperature in ON state, or in OFF state with timer set.
Then the temperature setting will blink on the LCD, indicating it entering setting mode.
Each time " " button is pressed, temperature setting rises by 1C.
Each time " " button is pressed, temperature setting lowers by 1C.
Setting temperature is finished 3 seconds after setting temperature value blinking.
*HEATING, COOLING, DRY
FAN ONLY
*:
1. Heating mode is unavailable for COOLING ONLY models.
2. When setting temperature is above setting range, "
temperature will not rise or lower any more.
4. Fan Speed Setting
Press "SPEED" button to select fan speed in ON state, or in OFF state with timer set. Each time "SPEED"
button is pressed, the fan speed changes in the following sequence:
LOW
(Display lights on in turn as indicated by the arrow)
1
2
4
DRY FAN ONLY HEATING
Range of Temperature Setting
16℃ ~30℃
Unable to set
MEDIUM HIGH
1. Turning ON/OFF
To start operation
When pressing the ON/OFF button in OFF state, the ON
indicator lights up and the starting command will be sent
to air conditioners in the group/zone.
To stop operation
When pressing the ON/OFF button in ON state, the ON
indicator turns off and the shutdown command will be
sent to air conditioner in the group/zone.
At this time, the set weekly timer ON (if any) will take
effect.
To completely shut down
Hold down "ON/OFF" button for more than 3 seconds,
the central controller will enter completely shutdown state
(at this moment, the timer ON is disabled and the
appliance only can be started manually), the ON indicator
turns off, and shutdown command will be sent to air
conditioners in the group/zone.
" will display on the LCD, and setting
AUTO
84