Hisense YXE-A03U Technical & Service Manual page 38

2. Wired Controller(YXE-C02U1(E))
Button Locked
After the wired controller setting is completed, lock buttons to
avoid wrong operation by children and others. All operations
are disabled after button lock function has been set.
How to activate:
Press and hold " ENTER " button for 3s to activate button lock
function, and icon will be displayed on the LCD.
How to cancel:
Press and hold " ENTER " button for 3s again to unlock, and
icon will disappear from the LCD.
NOTE:
For button locked by the next higher command of central controller, it cannot be cancelled, and only be
unlocked by the central controller.
Clock Setting
In case of any clock loss due to first startup and long-time
shutdown, it is required to set the clock.
Setting method:
1. After startup, all indicators for days of the week and for the
clock on the display screen flicker.
2. Press the " " and "
values of days of the week, hours, and minutes.
3. Press the " ENTER " button to confirm the setting, the indicators
for days of the week, hours, and minutes stop flickering, then the
setting is completed.
NOTE:
Pressing and holding down the "
Clock Correction
When the clock value is not consistent with the standard time, the
clock shall be corrected.
Setting method:
Hold down the "ON/OFF" button for 3s, the wired controller will be
shut down, and hold down the "TIMER/CLOCK" button for 3s
again, it will go into the clock correction mode.
Adjust the clock in the following sequence:
Days of week
1. First, the cursor right above days of week will flicker, and then you can press the "
button) and " " (minus button) to adjust the date to the required one, e.g., Thursday
, and press the "ENTER" button to confirm the settings.
2. Next, the hours setting icon
(plus button) and "
"ENTER" button to confirm the settings.
3. At last, it proceeds to minutes setting in sequence (the setting method is the same to that for
hours).
The icons will stop flickering after the clock correction setting is completed.
NOTE:
1. Pressing and holding down the "
2.When the wired remote controller is connected to the integrated control network, the clock will automatically
keep consistent with the integrated controller.
" buttons to respectively adjust the set
/ " button causes the value to increase continuously and rapidly.
Minutes
Hours
will flicker in succession, and then you can press the "
" (minus button) to adjust the hour to the required one, and press the
/ " button causes the value to increase continuously and rapidly.
1
36
Clock
Indicator for
days of week
2
3
2
" (plus
"