Hisense YXE-A03U Technical & Service Manual page 7

2. Wired Controller(YXE-A03U(E))
Simple Operation
This wired remote controller should be used with the air conditioner, and it can be used for cooling,
heating, drying and fan, etc. F
in this manual.
1. ON/OFF
Press ON/OFF button
appliance will stop operating.
2.Mode Setting
Used to select different operating modes and switch between cooling – dry – fan – heating and AUTO.
Every time the mode button
COOLING
NOTE:
AUTO mode is unavailable on some of the models and will be invalid during mode setting. For cooling
only and heating disabled models, heating mode is invalid during mode setting.
3. Temperature Setting
Press " " or " " button to enter temperature setting state.
Each time " " button is pressed, the temperature setting rises by 1℃；
Each time " " button is pressed, the temperature setting lowers by 1℃；
Temperature setting is finished 3 seconds after the set temperature value blinking.
*HEATING, COOLING, DRY
FAN
*:
1. Heating mode is ineffective for COOLING ONLY models.
2. The default setting range depends on indoor unit.
3.When the set temperature exceeds the range mentioned above, the set temperature cannot be
increased or decreased anymore and icon
4. Fan Speed Setting
Press the fan speed button "
following order:
(The icons will be turned on circularly
along the direction of arrow)
NOTE:
AUTO fan is invalid for "FAN" mode.
AUTO fan speed is the default setting in DRY mode, and it can not be adjusted.
or other functions and settings, please refer to the specific operation
, and the appliance will start to operate; once this button is pressed again, the
is pressed, the operating mode will change in the following sequence:
DRY FAN
Range of Temperature Setting
16℃~30℃
Unable to set
" in ON state to adjust the fan speed. The fan speed will change in the
AUTO
HIGH
HEATING AUTO
will be displayed on the liquid crystal display.
MEDIUM
5
LOW