Hisense YXE-A03U Technical & Service Manual page 41

2. Wired Controller(YXE-C02U1(E))
2. Timer ON hour flickers, and press "
button) to select the desired time.
Each time " " button is pressed, time increases by 1 hour;
Each time " " button is pressed, time decreases by 1 hour.
Pressing and holding down the "
to increase continuously and rapidly.
After timer ON hour has been set, press "ENTER" button to
return to Timer ON minute setting.
If you don't need Timer OFF setting, press "CANCEL" button to
cancel.
3. Timer OFF setting is the same step with Timer ON setting.
4. After TIMER ON/OFF setting is completed, press "
button)/ " " (minus button) to select the desired day, press
"ENTER" button to confirm it, or press "CANCEL" button to
cancel. The selected day will be marked with " ".
For example,
is effective.
5. Continue group 2 setting, repeat the same setting procedure as
group1. Four groups Timer ON/OFF can be set at most .
6. You can quit WEEKLY TIMER setting by pressing "TIMER/CLOCK"
or "ON/OFF" button when group number is flickering.
Weekly Timing Inquiry
When the weekly TIMER function is available, it will go into the weekly timing inquiry if you press the
"TIMER/CLOCK" button. Press the plus button "
timer moment.
NOTE:
If you need to temporarily leave for a few days when weekly timer has been set, meanwhile Timer ON/OFF
is not permitted to work and continue to work after you are back, you can hold down "ON/OFF" button for 3
seconds to turn it off completely. At this moment, weekly timer set time can still be saved, but the air conditioner
will not run. Weekly timer setting resolution is 1 minute. Timer ON/OFF signal is effective within 1 minute.
Buzzer Indicator Selection
The buzzer beeps by default when the controller is operated.
If you need mute operation, hold down "FAN" button for 3 seconds,
the buzzer beeps for 4 times indicating setting has been successfully
changed. Repeat the same steps to return to the original setting.
Dimmer Setting
The screen is bright by default.
hold down "MODE" button for 3 seconds, the buzzer beeps for 4
times indicating setting has been successfully changed.
Repeat the steps above to return to the original setting.
"(plus button) or "
/ " button causes the value
shows any day of a week selected
" or minus button "
If you need the screen to be dark,
39
" (minus
Timer group select
" (plus
TIMER day select
" to inquire the previous or the next
TIMER ON set
TIMER OFF set