Ac Breaker - Christie Cinema 4K-RGB Service Manual

8. Loosen the four screws securing the card cage.
9. Pull on the locking pin located through the access door, above the card cage intake fan.
10. Slide the card cage out along the guides.
To avoid possible damage, carefully place the card cage on a clean, flat surface.
11. To re-install, follow these steps in reverse order.

AC breaker

The AC breaker is located at the rear of the projector.
1. Remove the rear cover (on page 39).
2. Uninstall the ground harness ends.
3. Remove the four screws.
Cinema 4K-RGB Service Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102713-06 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Electronics
46