Removing The Power Supply From A Multiservice Switch 7460 - Nortel 7400 Hardware Installation

Removing the power supply from a Multiservice
Switch 7460
Prerequisites
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Remove the power supply from a Nortel Networks Multiservice Switch 7460
if it fails.
CAUTION
Risk of service loss
Do not overload the power supplies. One power supply
can support a maximum of one or two CPs and six or
seven FPs up to a total of eight processor cards.
WARNING
Risk of personal injury
Power supplies weigh 5.7 kg (12.57 lb) each. Handle
carefully and avoid dropping.
WARNUNG
Verletzungsgefahr
Die Stromversorgungsgeräte haben ein Gewicht von
jeweils 5,7 kg. Seien Sie vorsichtig beim Umgang mit
dem Gerät, und vermeiden Sie, es fallenzulassen.
WARNING
Damage to equipment by electromagnetic interference
To meet electromagnetic interference (EMI) regulatory
requirements and thermal specifications, each empty
power supply bay must be covered with power supply
filler (blank). Power supply fillers are removed and
installed using the same method as power supplies.
Chapter 39 Hardware procedures 471