Unpacking A Multiservice Switch 7480 - Nortel 7400 Hardware Installation

536 Chapter 39 Hardware procedures

Unpacking a Multiservice Switch 7480

Prerequisites
Procedure steps
NN10600-175 6.1S2
Unpack a Nortel Networks Multiservice Switch 7480 as close as possible to
the installation site.
CAUTION
Avoid structural stress when maneuvering uncrated
shelf assemblies
When handling and moving uncrated shelf assemblies,
avoid strain, excessive shock or vibrations that can
damage or warp the equipment.
1 Use a knife to open the packaging.
2 Place the control and function processor boxes (labeled with their names
and Nortel Networks part numbers) and termination panel boxes to one
side. You can unpack them later.
CAUTION
Risk of electrostatic damage
When handling circuit cards, wear a grounded antistatic
wrist strap or equivalent protection to avoid damaging
electronic parts.
3 Take each remaining unit of equipment from its box, and carefully remove
its protective packaging.
4 Inspect the equipment for damage. If any equipment is damaged, contact
your purchasing department and arrange to have it replaced.
5 Clear the unpacking area of all debris. Keep all the packing material and
containers in case the equipment has to be moved later.
6 Compare the contents of your shipment with the table "Equipment
checklist for unpacking a Multiservice Switch 7480" (page 537) and the
figure "Taking inventory after unpacking a Multiservice Switch 7480"
(page 538) to ensure that you have all the hardware you require.
If you purchased the device separately (not as part of a cabinet package)
Nortel Networks packages each unit of hardware separately.