Nortel 7400 Hardware Installation page 525

3 Verify that the cabinet will be placed off the pallet onto on a flat surface so
that it does not tip over after you stand it upright.
4 Use a pair of tin snips to cut the banding that secures the cabinet
packaging.
5 Remove the cardboard packaging on the top and sides so that the cabinet
remains resting on a tray of cardboard.
6 Without opening them, put aside all boxes containing control processors
(CPs), function processors (FPs), the power supplies, the termination
panels, and any other boxes. Each item is identified on the container by
its Nortel Networks product engineering code (PEC) NTxxxxaa or part
number Pnnnnnn.) Unpack them later when appropriate antistatic
equipment protection will be specified for the installation procedure.
If the cabinet was shipped in wrapping material other than cardboard,
there can be some electrostatic energy build-up as you remove this
material. This is normal.
7 Slide the cabinet along the tray until the foot of the cabinet clears the tray.
8 Lift the cabinet from the top end and stand it upright on the floor.
9 Inspect the equipment for damage. If any equipment is damaged, contact
your Nortel Networks sales representative to arrange having it replaced.
10 Remove and retain any assembly parts that are attached to the framework
or cabinet.
11 Clear the unpacking area of all debris.
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Chapter 39 Hardware procedures 525
WARNING
Risk of personal injury
The banding that secures the cabinet packaging is under
pressure and can fly up when cut.
WARNUNG
Verletzungsgefahr
Die Gehäuseverpackung ist mit einem Spannband
gesichert. Seien Sie vorsichtig beim Durchschneiden des
Bandes, da es möglicherweise mit Gewalt aufspringt.