Unpacking And Removing A Seismic Cabinet From A Pallet - Nortel 7400 Hardware Installation

Unpacking and removing a seismic cabinet from a pallet

Procedure steps
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Unpack and remove a seismic cabinet in a dust-free area near the installation
site.
1 Move the pallet close to where it is to be installed.
2 Remove and keep the packing slips and shipping papers attached to the
outside packaging.
3 Carefully cut the plastic stretch wrap around the cabinet.
WARNING
Risk of personal injury
The banding that secures the cabinet packaging is under
pressure and can fly up when cut.
WARNUNG
Verletzungsgefahr
Die Gehäuseverpackung ist mit einem Spannband
gesichert. Seien Sie vorsichtig beim Durchschneiden des
Bandes, da es möglicherweise mit Gewalt aufspringt.
4 Use a pair of tin snips to cut the banding that secures the cabinet
packaging.
5 Lower the ramp that is attached to the pallet as shown in "Lowering the
pallet ramp" (page 546).
Chapter 39 Hardware procedures 545