Nortel 7400 Hardware Installation page 402

402 Chapter 39 Hardware procedures
NN10600-175 6.1S2
Figure 147
Multiservice Switch cabinet footprint
Smaller grille
A
Cabinet footprint
A: Anchoring radius is 7.6 cm (3 in.) from the centre of the levelling feet
2 Drill each hole and clean thoroughly with a vacuum cleaner.
3 Cover the holes with acetate tape to prevent them from being filled with
debris.
4 Position cutouts for routing cables under a floor directly beneath the
smaller grille at the base of the cabinet cutout. See the figure "Floor cutout
position and size for under floor cable routing" (page 403).
Levelling foot
2.75 cm
(1.1 in.)
2.75 cm
(1.1 in.)
Front
60 cm
(23.6 in.)
Anchoring circle
60 cm
(23.6 in.)