Switch 7440 - Nortel 7400 Hardware Installation

408 Chapter 39 Hardware procedures
Removing a 13-inch termination panel from a Multiservice

Switch 7440

Prerequisites
Procedure steps
NN10600-175 6.1S2
Remove a termination panel from a Nortel Networks Multiservice
Switch 7440 to replace a failed panel or if you are removing its associated
FP(s) from the shelf.
CAUTION
Risk of equipment damage
When installing or removing a 13" termination panel
from a Multiservice Switch 7440, do not force the
bottom of the termination panel against the cable
manager.
1 Label the cables connected to the termination panel. Then, remove the
cables and coil them carefully out of the way.
2 Remove the screw at the end of the termination panel that holds the panel
in position. See the figure "Removing 13" termination panels from the rear
of a Multiservice Switch 7440" (page 409).
3 Tip the termination panel backward and lift it out.
Be careful when you remove the termination panel. Tip the top of the
termination panel away from the cabinet far enough to clear the housing.
Take care not to not pry the upper cable manager off the rear housing.
4 Replace the screw that you removed in step 2.