Removing A Shelf Interconnect Cable - Nortel 7400 Hardware Installation

Removing a shelf interconnect cable

Procedure steps
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Remove a shelf interconnect cable between two Nortel Networks
Multiservice Switch 7480s to replace a broken cable, or if you are removing
one of the shelves.
1 Disconnect the shelf interconnect cable from the Alarm 2 connector on the
back of each shelf. See the figure "Dual alarm shelf interconnection
between two Multiservice Switch 7480s" (page 440).
Chapter 39 Hardware procedures 439