Routing Card Cables On A Multiservice Switch 7480 - Nortel 7400 Hardware Installation

516 Chapter 39 Hardware procedures

Routing card cables on a Multiservice Switch 7480

Procedure steps
NN10600-175 6.1S2
Route processor card cables through the cable management assembly on top
of the Nortel Networks Multiservice Switch 7480 to keep them organized.
1 Open the cable management assembly door.
2 Route the cables from the faceplate of each processor card through the
cable management assembly above the shelf assembly. The smaller
channels in the cable guides are for fiber optic cables. See the figure
"Routing cables through a cable management assembly for a Multiservice
Switch 7480" (page 517).
3 Label all processor card cables near the connector to indicate the if it is a
receive or transmit cable.
4 Secure cables to the sides of the cabinet to ensure that proper airflow
around the shelves. Always ensure that you do not pinch cables,
especially fiber cables.
5 Close the cable management assembly door to hold the cables in place.