Removing A Multiservice Switch Cabinet From A Pallet - Nortel 7400 Hardware Installation

432 Chapter 39 Hardware procedures

Removing a Multiservice Switch cabinet from a pallet

Prerequisites
Procedure steps
NN10600-175 6.1S2
After you unpack the Nortel Networks Multiservice Switch cabinet, remove
it from its pallet. If the cabinet is the seismic version, see the procedure
"Unpacking and removing a seismic cabinet from a pallet" (page 545).
WARNING
Risk of personal injury
A cabinet that contains one device weighs 200. kg
(441 lb). You need four people to move this cabinet.
A cabinet that contains two devices weighs 313. kg
(689 lb). You need six people to move this cabinet.
WARNUNG
Verletzungsgefahr
Ein Gehäuse mit einem Switch wiegt 200 kg. Zum
sicheren Bewegen dieses Gehäuses werden vier
Personen benötigt.
Ein Gehäuse mit zwei Switches wiegt 313 kg. Zum
sicheren Bewegen dieses Gehäuses werden sechs
Personen benötigt.
CAUTION
Avoid structural stress when maneuvering uncrated
cabinets and shelf assemblies
When handling and moving uncrated cabinets and shelf
assemblies, avoid strain, excessive shock, or vibrations,
which can damage or warp the equipment.
1 Remove and keep the packing slips and shipping papers attached to the
outside packaging.
2 Ensure that the pallet is on a flat surface.
3 The anchor brackets fasten the cabinet to the pallet with lag bolts. Use an
open-end wrench or socket wrench to loosen the lag bolts. The figure