206 Chapter 39 Hardware procedures
Anchoring a seismic cabinet using an outside-mount
anchoring kit
Prerequisites
Procedure steps
NN10600-175 6.1S2
Anchor a seismic cabinet using an outside-mount anchoring kit to achieve
NEBS compliance.
•
You need an outside-mount anchoring kit with PEC NTFN37.
1
Drill the holes for each of the anchors. Use a roto hammer drill and 1/2"
masonry drill bit to drill the holes. Wear safety goggles when you drill the
holes.
2
Clean each hole thoroughly with a vacuum cleaner.
3
Tip the cabinet and remove the casters and levellers from the bottom of
the cabinet. You need at least one person to support the cabinet while
another person removes the casters and levellers.
4
Bolt the brackets to the front and back of the cabinet using the eight bolts
provided. See "Seismic cabinet mounting—front view" (page 207).