Nortel 7400 Hardware Installation page 548

548 Chapter 39 Hardware procedures
Figure 214
Removing the pallet
one person must
remove the pallet after
you tilt the cabinet
NN10600-175 6.1S2
As you pull the pallet back, the wooden slides that support the left and
right sides of the cabinet help you gently lower it down the ramp.
9 Tilt the cabinet to the left and right sides enough to remove the wooden
slides one after the other. This allows the cabinet to rest on its casters.
10 Roll the cabinet on its castors into the anchoring position. The casters are
intended for short distances and will not cross the threshold of a doorway
or elevator.
11 Adjust the levelers downward to remove the weight from the casters. Use
a spirit level to ensure that the cabinet is level.
rear front
two people must
support the cabinet
slides, left and
right