Disconnecting A Local Operator Terminal Or Modem From A Device - Nortel 7400 Hardware Installation

Multiservice switch

Hide thumbs Also See for 7400:

Table of Contents

224 Chapter 39 Hardware procedures

Disconnecting a local operator terminal or modem from a

Procedure steps

NN10600-175 6.1S2

Disconnect a local operator terminal or modem from a device if you no longer

need to use the device or if you need to replace the cable.

Disconnect the V.24 cable connected to port 1 on the faceplate of the CP

by loosening the captive screws. See "Local operator port on the CP

faceplate" (page 223).

Remove the cable. If the cable has been run through the cable

management assembly, be careful not to disrupt other cables in the

If necessary, disconnect the other end of the cable from the terminal or

7420 7440 7460 7480