Table of Contents
Advertisement
CrossLink-NX Evaluation Board
User Guide
4.3. JTAG to MSPI Pass-through Interface
The download controller can also access the JTAG to MSPI pass-through circuit that allows the slave SPI Flash to be
erased, programmed, and read with Radiant Programmer.
4.4. SPI Flash Device Selection in Programmer
The Flash device on this board is a Macronix MX25L12833F.
Figure 4.2. SPI Flash Operation Dialog
You may proceed with the Flash device programming by following the procedure in
CrossLink-NX sysCONFIG Usage
Guide
(FPGA-TN-02099).
© 2019-2021 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal.
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
16
FPGA-EB-02028-1.4
Advertisement
Table of Contents
