Processor Heat Sink Module (Phm) And Processor Removal; Figure 101. Processor Carrier Clip Identifier Markings; Figure 102. Phm Assembly Removal From Processor Socket - Intel M50FCP2UR Integration And Service Manual

Intel® Server System M50FCP2UR System Integration and Service Guide
Note: The etched identifier location in the figure is for illustration purposes only. The location and color may
be different on the actual processor and carrier clip
6.6.1

Processor Heat Sink Module (PHM) and Processor Removal

1. Power off the system and disconnect all system power cords
2. Remove the system top cover (see
3. Remove the air duct (see
4. Ensure the anti-tilt wire on the four corners of the heat sink, is in the outward position (see Letter A).
5. Fully unscrew all four heat sink fasteners in any order (see Letter B).
6. Push the anti-tilt wire on the four corners of the heat sink, to the inward position (see Letter C).
7. Lift the PHM straight up and away from the server board (see Letter D).
8. Place the PHM, bottom side up, on a flat surface.
9. Visually inspect that the socket is free of damage or contamination.
Caution: If debris is observed, blow it away gently. Do not use tweezers or any other hand tools to
remove the debris.
80

Figure 101. Processor Carrier Clip Identifier Markings

Figure 102. PHM Assembly Removal from Processor Socket

Section
Section 6.2.1).
6.1.1).