Table of Contents
Advertisement
Intel® Server System M50FCP2UR System Integration and Service Guide
3.10 Trusted Platform Module (TPM) Installation
This section provides instructions for the installation of a Trusted Platform Module (TPM). Refer to the Intel®
Server M50FCP Family Configuration Guide for available options.
Required Tools and Supplies
Intel® TPM accessory kit
•
•
Anti-static wrist strap and conductive workbench pad (recommended)
Flat head screwdriver
•
1. Power off the system and disconnect the system power cords.
2. Remove the system top cover (see
3. Remove the air duct (see
4. Locate and carefully unpack the TPM kit contents.
5. Locate the TPM module connector on the server board.
6. Insert the plastic stand-off into the server board mounting hole (see Letter A).
7. Place the TPM module over the connector and confirm the orientation of the module.
8. Press the module down onto the connector (see Letter B).
9. Secure the TPM module to the stand-off with either the standard screw or the tamper resistant screw
(see Letter C).
Note: As a security feature that deters unauthorized removal of the TPM from the server board, Intel
recommends using the tamper resistant screw type. Once installed, its removal is exceedingly
difficult.
10. Reinstall the air duct (see
11. Reinstall the system top cover (see
58
Figure 66. Trusted Platform Module (TPM) Installation
Section
Section
2.3.1.
Section
2.3.2).
Section
2.2.1).
2.2.2).
Advertisement
Table of Contents
