Figure 114. Tighten Heat Sink Fasteners - Intel M50FCP2UR Integration And Service Manual

Intel® Server System M50FCP2UR System Integration and Service Guide
4. Carefully lower the PHM onto the bolster plate alignment pins (see Letter B).
5. Set all four anti-tilt wires on the heat sink to the outward position (see Letter C).
6. Using a T30 Torx* screwdriver, tighten the heat sink fasteners to 8 in-lb. No specific sequence is
needed for tightening.
7. Reinstall the air duct (see
8. Reinstall system top cover (see
Important: Do not install a processor heat sink on an empty socket. Only install a socket cover on an empty
socket.
86

Figure 114. Tighten Heat Sink Fasteners

Section 6.2.2).
Section 6.1.2).