Colorlight Calibration Pro User Manual page 90

software, and check all plug-ins of the software when installing.
Q: Failed to shoot the photos.
A: 1. Confirm that the camera model is supported by the software (Software currently
only support part of the Canon camera, please contact the technical support for
details), please pay attention that the EOS 7D is not the same as the EOS 7D MARK
II.
2. Confirm that the camera is shift to manual mode (M mode).
3. Close the lens auto-focus function.
Q: Why the shutter can't be set more than 1/30?
A: 1. Confirm that the camera is shift to manual mode (M mode).
2. Confirm that the multi-function dial is set to shooting mode instead of movie
mode.
Q: Fail to analyze photos.
A: 1. Confirm that the camera model is supported by the software (Software currently
only support part of the Canon camera, please contact the technical support for
details), please pay attention that the EOS 7D is not the same as the EOS 7D MARK
II.
2. Try to re-install the software to ensure that components are completed.
3. Please check the shooting quality. Check it like this: click [ open...] in the
[ Photos ] page, then using brightness extract, grey-scale map or histogram function
to manual analysis photos whether there is out of focus, overexposure, underexposure,
shake, etc.
4. Partition is so large that leads to the dense lamp. (Using the skip point function
to reduce lamps density)
5. Too much broken point/dislocation can affect the results of the analysis.
6. The available memory is limited.
Q: The shooting quality is bad after shooting again and again.
A: Out of focus:
1. SLR cameras need to start EVF or use the camera's LIVE mode focus in order
to improve the focusing accuracy.
2. Using manual focus to improve accuracy when the auto focus effect is not
good enough.
Overexposure/underexposure:
Calibration Pro User Manual
84