Show System; Show System Log - Nortel BayStack 820 Installation And Reference Manual

Installation and Reference for the BayStack 820 ISDN Router

show system

Displays system and SNMP related configuration information. You can use
individual commands to change this information, except for the S/W and H/W
version numbers. This information is hard-coded for the router.
Example
BayStack> show system
System Name: BayStack 820 Router Up Time: 3months
-----------------------------------------------------------
system description:
system contact:
system location:
community string (read):
Trap generation:
Total Serial Ports: 1
MAC Address:
Console Baud Rate: 19200
Console Timeout:
Remote Management State:
DHCP State:
IP RIP Mode:
IP Multicast State:
IP address:
Private IP address:
Enabling Key:
SNMP Filter NAS CLI L2L IPX Bridging VPN Encryption

show system log

Displays the system log for the router. The system log contains logs of various
router events, depending on the log level you set with the
command
or down (log level 2), as well as certain protocol progress messages for
troubleshooting.
When you execute this command, 22 entries are displayed at a time. Each
sequential execution of the command displays the next 22 entries until the entire
log is displayed. For example, if there are 60 entries in the log, the first
system log
entries 23 through 44, and the next command shows entries 45 through 60,
10-68
IP/IPX Brouter Over ISDN Line
Abigail Bruce, pager (210) 555-7890
7800 I10 West, Santa Clara, CA 94030
public
Disabled
S/W Version:1.00
00-60-20-10-00-70
10(min)
Enabled
Enabled
Active Ver.1
Disabled
0.0.0.0
192.168.168.207 network mask: 255.255.255.0
3W2ED6R Enabled features:
(page 10-64). Common events include login, a PPP connection goes up
command shows log entries 1 through 22, the next command shows
H/W Version:
Learning State:Enabled
IPX frame type:
IPX RIP/SAP State: Enabled
network mask: 0.0.0.0
HTTP Compression Multicast
1 days 21:21:05
1.0
802.2
set log level <1-10>
show
206901-A