Nortel BayStack 820 Installation And Reference Manual page 234

Installation and Reference for the BayStack 820 ISDN Router
Table B-1. System Messages
Message
Invalid far end IP address.
Invalid Filter IP Address.
Invalid Filter Name.
Invalid gateway configuration.
Invalid IP address.
Invalid MAC address.
Invalid near end IP address.
Invalid profile name, please use
another.
Invalid remote extension number.
Invalid remote IP address.
Invalid static DHCP IP address.
Invalid sub-address for DOVBS.
Invalid tunnel name.
Invalid tunnel remote IP Address.
B-6
(continued)
Meaning
An invalid IP address has been entered in the Far End IP Address
field. This field appears only for dedicated ISDN lines (e.g., 64K
permanent or IDSL/perm 128K).
An IP address with a syntax error has been entered. An IP address
should be a set of four three-digit numbers. Each three-digit
number should be between 0 and 255, inclusive. For example, a
correct IP address is 192.168.100.2.
The filter name entered is not valid. A filter name should be
between one and 30 characters (numbers, letters, dashes or
underscores).
An invalid value has been entered in the Gateway field while
attempting to add a static IP or IPX route.
The IP address entered is not valid.
The format of the MAC address you entered is not correct or the
MAC address entered in the DHCP static assignment table is not
valid or is formatted incorrectly. The correct format is
xx-xx-xx-xx-xx-xx, 6 pairs of hexadecimal digits (0-9, and a-f)
separated by dashes.
An invalid IP address has been entered in the Near End IP
Address field. This field appears only for dedicated ISDN lines
(e.g., 64K permanent or IDSL/perm 128K).
The selected profile name is reserved by the system. Enter
another name.
The remote extension number entered in the speed dial table is
not valid. Remote extension numbers are up to eight digits within
the range of 0 to 9.
The remote IP address entered in the VPN tunnel configuration is
not valid.
The IP address entered in the static DHCP configuration form is
invalid. Check the parameters in the entry and then try again.
A duplicate sub-address has been entered in the Port 1 Data over
Voice Bearer Service. The sub-address has been used in the voice
adapter configuration or speed dial number configuration.
The tunnel name entry is empty or not acceptable.
An IP address with a syntax error has been entered in a tunnel
configuration. An IP address should be a set of four three-digit
numbers. Each three-digit number should be between 0 and 255,
inclusive.
206901-A