Nortel BayStack 820 Installation And Reference Manual page 238

Installation and Reference for the BayStack 820 ISDN Router
Table B-1. System Messages
Message
Static entry not found.
Statistics Cleared.
Static DHCP Entry Not Found.
Static routes to single user profiles not
allowed.
Switch type/Directory numbers
reconfigured. Related voice adapter
settings have been reset.
The system is disconnecting.
System received incomplete user's
command. Please try again.
The system time has been configured
successfully.
Test successful.
There is an active window monitoring
the system status on "xxx.xxx.xxx.xxx."
This operation will cause a system
reset upon completion. All unsaved
configuration changes will be lost. Do
you want to continue (Y/N)?
This profile doesn't exist any more.
Tunnel does not exist.
Upper bound address is out of range
(231-254).
Value for idle time is invalid - choose
between [0, 3600].
B-10
(continued)
Meaning
An attempt was made to locate an entry which does not exist.
The router has completed a clear statistics operation on the link
selected in the System Status Monitoring Window.
A DHCP entry must be selected to edit or delete.
You entered an illegal configuration. Static routes can be
configured only over Internet access or remote office access
configuration profiles. You cannot configure a static route for a
dial-in user connection profile.
Changing the ISDN switch type parameters has caused the voice
adapter settings to be reset to default settings. You must
reconfigure the voice adapter settings, if necessary.
You attempted to disconnect the router, while the router is in the
process of disconnecting an active connection.
An internal error has occurred. Retry the operation.
The router's time has been successfully configured.
The Apply and Test operation is successful.
A system status monitoring window is opened on the workstation
with the indicated IP address (xxx.xxx.xxx.xxx). Only one system
status monitoring window is allowed at a given time.
A firmware download operation through a directly connected
console session will cause a system reset after the operation is
complete. Ongoing operations may be interrupted and that any
configuration changes made within the last 30 minutes (the default
time period for automatic configuration saves) may be lost as a
result of the reset.
The configuration profile being configured no longer exists in the
system. Please reload or refresh the browser page and try again.
An attempt has been made to delete a tunnel that does not exist.
The IP address entered in Dial In IP Address-High field is not valid.
It should be in the range of 232 to 254, and at least one number
higher than the lower bound IP address configured.
The value for the idle time parameter was entered incorrectly. The
correct values are 0 if no idle timeout is desired, or one to 3600
indicating the number of seconds since the link has not carried any
data traffic before it is automatically disconnected.
206901-A