Ping Ipaddr [<N_Times> < N_Size>]; Set Ip Default Route <Gateway_Ipaddr; Set Ip Default Route <Profile_Name; Set Ip Lan <Ipaddr> <Netmask - Nortel BayStack 820 Installation And Reference Manual

IP RIP broadcasts are sent only when the connection is up. The router responds to
these control packets for a default period of 10 minutes, unless you specify a
specific time period (from one minute to 60 minutes).
Example
BayStack>
BayStack>
ping IPaddr [<n_times> < n_size>]
For a description of this command, refer to
n_size>]
set ip default route <gateway_IPaddr>
set ip default route <profile_name>
Sets the IP default route. The default route is used when an IP packet's destination
IP address cannot be found in the IP routing table. If the default route is not
defined, such a packet is discarded.
Example
BayStack>
BayStack>
set ip lan <IPaddr> <netmask>
Assigns the specified "public" IP address to the LAN port of the router. When you
use this command, the LAN port maps to two IP addresses (one public and one
private), and is therefore on two networks.
Example
BayStack> set ip lan 204.71.220.153 255.255.255.0
206901-A
enable spoofing isdn1 iprip
disable spoofing isdn2 iprip
on page 15.
set ip default route 204.71.220.153
set ip default route billerica
Using the Command Line Interface
ping <IPaddr> [<n_times> <
10-27