Nortel BayStack 820 Installation And Reference Manual page 235

Table B-1. System Messages
Message
Invalid tunnel remote system name.
IP Address is invalid.
Lower bound address is out of range
(231-254).
Local name is required.
Maximum number of tunnels
exceeded. No more are allowed.
MAC Address was not specified.
Management session time out.
The menu option you clicked on can't
be found. Please try again.
NAT fails to do translation. The protocol
of the packet isn't supported.
NAT fails to do translation. NATT not
found for an outgoing ICMP error
message.
NAT fails to get proxy entry. Null proxy
structure.
The new password does not match the
confirmed password.
The new password is the same as the
old password.
Not a static route.
Only 8 rules allowed.
Parameters Accepted/ Applied
parameter accepted.
206901-A
(continued)
Meaning
A remote system name has not been provided or is invalid. Each
tunnel configuration requires a remote system name for
authentication.
The IP address entered as the router's public or private address
was not valid.
The IP address entered in the Dial In IP Address-Low field is not
valid. It must be a number in the range from 231 to 254, and at
least one lower than the upper bound IP address configured.
The local name of a tunnel is not configured. It is a required
parameter.
The maximum number of tunnels has been exceeded. To
configure another, an existing tunnel configuration must be
deleted.
The MAC address in the static DHCP entry configuration must be
from one to 12 hexadecimal digits (0-9, a-f).
A Web browser management session has been idle for more than
the configured time out. The default timeout is 10 minutes.
An internal error has occurred. Try this operation again.
A Network Address Translation operation failed because the
packet protocol type was unknown or is not supported.
An attempt to perform a Network Address Translation operation on
an ICMP packet (for example, ping) has failed. The Network
Address Translation table entry could not be found.
An internal error occurred. Please contact customer support.
The confirmation password entered is not the same as the new
password entered during the password operation.
The new password is the same as the old password.
An attempt has been made to delete a non-static route in the IP
routing table. Only static routes can be deleted.
The maximum number of filtering rules, system-wide, has been
exceeded. To add an additional rule, one must be deleted.
All parameters entered were acceptable for use by the router.
System Messages
B-7