In the interest of improving internal design, operational function, and/or reliability, Nortel Networks reserves the right to make changes to the products described in this document without notice. Nortel Networks does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.
Page 3
(such as images, text, recordings or pictures) and related licensed materials including all whole or partial copies. Nortel Networks grants you a license to use the Software only in the country where you acquired the Software. You obtain no rights other than those granted to you under this License Agreement. You are responsible for the selection of the Software and for the installation of, use of, and results obtained from the Software.
Page 4
This License Agreement is governed by the laws of the country in which Customer acquires the Software. If the Software is acquired in the United States, then this License Agreement is governed by the laws of the state of New York.
New in this release Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs is a new document for release 4.0, based on Nortel Ethernet Routing Switch 8600 Installation — SFP and XFP Tranceivers and GBICs (NN46205-305). The following section lists the features contained in this document.
To avoid the transfer of oil or other contaminants from your fingers to the end face of the ferrule, handle connectors with care. Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Do not allow the air extension tube to touch the bottom of the optical port. —End— Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Do not discard the shroud. On retractable shroud connectors, hold the shroud in its retracted position. —End— Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Never look into an optical fiber or connector port. Always assume that fiber optic cables are connected to a light source. ATTENTION ATTENTION Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Procedure job aid: SFP models without DDI support SFPs are hot-swappable input/output enhancement components designed for use with Nortel products to allow Gigabit Ethernet ports to link with other Gigabit Ethernet ports over various media types. The SFPs described in this section do not have Digital Diagnostic Interface capability, and are RoHS -E5 compliant.
SFP are supported. Access to the DDI information will be provided in a future release. The SFPs described in this section are all RoHS -E6 compliant. The following table lists and describes the Nortel SFP models with DDI capability. All these SFPs use LC connectors. SFP models with DDI capability...
22 Small form factor pluggable transceivers Installing an SFP Install an SFP to provide an interface between the switch and the network cable. Installing an SFP takes about 3 minutes. Prerequisites • Verify that the SFP is the correct model for your network configuration.
Factor Pluggable (XFP) transceivers, and lists some technical specifications for the supported XFP models. Nortel recommends that you only use Nortel qualified XFPs. If you do choose to use other vendor XFPs, be aware that Nortel does not support the use of other XFPs. Navigation •...
Procedure job aid: XFP models XFPs are hot-swappable input/output enhancement components designed for use with Nortel products to allow 10 Gigabit Ethernet ports to link with other 10 Gigabit Ethernet ports. Digital diagnostic monitoring (DDM) allows real-time access to device operating parameters. All XFPs come with DDM capability.
-5 to 85C for RoHS -E6 models 0 to 60C for RoHS -E5 models -40 to 85C 300 mA unless otherwise stated 1.0 W unless otherwise stated Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Specifications Duplex LC SMF, 9 µm 1.0 Gbit/s 1.25 Gbit/s 0 to 60C 20 dB -3.0 to 2.0 dBm -23 dBm -3.0 dBm Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Page 37
1.25 Gbit/s Up to 10 km 1310 nm and 1490 nm 11.0 dB 3.3 dB -3.0 dBm -9.0 dBm -19.5 dBm -3.0 dBm Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
For more details, see these standards documents. All Nortel XFPs meet or exceed these standards. Nortel recommends that you only use Nortel-qualified XFPs. If you do choose to use other vendor XFPs, be aware that Nortel does not support the use of other XFPs. Navigation •...
0.49 x 0.72 x 2.79 inches (in.) 12.5 x 18.35 x 71.1 millimeters (mm) LC ultra physical contact (UPC) -40 to 85C 0 to 70C Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Page 41
3.0 dB -128 dB per Hertz (dB/Hz) -12 dB -9.9 to -1.0 dBm 0 dBm -11.1 dBm -12 dB -7.5 dBm 12.3 gigaHertz (GHz) Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
42 XFP specifications The stressed sensitivity values are for system level BER measurements, which include the effects of CDR circuits. Nortel recommends that you allocate at least 0.4 dB additional margin if you make component level measurements without the effect of CDR circuits.
15 dB 3.0 dB at 40 km -4.7 to 4.0 dBm 30 dB -2.1 dBm -1.7 dBm -30 dBm 3.0 dB -128 dB/Hz Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
10GBASE-ZR 10.3125 Gbit/s ±100 ppm 10GBASE-ZW 9.95328 Gbit/s ±20 ppm 675 000 hours Up to 80 km 24 dB 3.0 dB at 80 km (G.652 fiber) Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Page 45
10GBASE-ZR 10.3125 Gbit/s ± 100 ppm 10GBASE-ZW 9.95328 Gbit/s ± 100 ppm -24 dBm and 9 -7.0 dBm 5.0 dBm -27 dB 9.3 GHz Nortel Ethernet Routing Switch 8300 Installation — SFPs and XFPs NN46200-307 01.02 Standard 4.0 27 August 2007...
Page 48
Document date: 27 August 2007 Sourced in Canada and the United States of America To provide feedback or report a problem in this document, go to www.nortel.com/documentfeedback. Nortel, the Nortel logo, and the Globemark are trademarks of Nortel Networks. IEEE is a trademark of the Institute of Electrical and Electronics Engineers, Inc.