Thermo Scientific Nicolet iS5 LS User Manual page 26

3
Maintaining the Instrument
Cleaning the Instrument
Checking the Humidity Indicators
22 Nicolet iS5 LS User Guide
• Do not touch any printed circuit board in the instrument (such as the circuit board on
the detector).
• Do not remove a replacement component from its protective packaging until you are
ready to install that component in the instrument.
Related Topics
• Electrical and Communication Cabling
• Troubleshooting the Instrument
If the outside of the instrument needs cleaning,
Then use a soft cloth that is damp (not wet) and a mild soap to clean the outside of the
instrument.
CAUTION To avoid a shock hazard, do not allow liquid to run into the power supply or
the vents at the back of the instrument.
NOTICE Do not use harsh detergents, solvents, chemicals or abrasives to clean the
instrument; these can damage the finish.
Related Topics
• Cleaning the Sample Windows
• Static Electricity Precautions
The instrument is tightly sealed and its optical components are protected by desiccant that
absorbs water vapor.
NOTICE Keep the instrument sealed and desiccated at all times and check the humidity
indicator regularly. Equipment damage due to failure to maintain seal and desiccation is
not covered under the warranty. If you have questions about this requirement,
Follow these steps to monitor the humidity level inside the instrument.
• Checking Humidity When the Instrument is Powered Off
• Checking Humidity When the Instrument is Powered On
turn it off and disconnect the power supply.
contact us.
Thermo Scientific