Executing A Shot Box Function With The Key 2 Row Cross-Point Buttons - Sony DVS-9000 User Manual

2
Press the memory recall button to which the shotbox register you want to
run is allocated.
• The shotbox execution is carried out.
• The pressed button lights yellow.
• The numeric keypad control block [SHOTBOX] button lights, and the
region selection button corresponding to the region for which the effect
is set also lights.
• If the selected shotbox register has auto run set, on recall the effect is
immediately executed.
When auto run is not set for the recalled register
Simply recalling the register does not run the effect. To do this, press the
[RUN] button in the keyframe control block.
Executing a Shot Box Function With the Key 2 Row
Cross-Point Buttons
You can use the key 2 row of each of the M/E-1 to M/E-3, and PGM/PST banks
in the same way as the buttons in the utility/shot box control block.
Note
To use this function, it is first necessary to assign the utility shot box mode
switching function to the control panel [PRE MCRO] button.
For details of the assignment operation, see "Assigning the utility/shot box
mode switching function" (page 313).
You can assign any shot box register to the cross-point buttons.
For details of the assignment operation, see "Assigning a function to the key 2
row cross-point buttons" (page 345).
1
Press the [PRE MCRO] button, turning it on.
2
Press one of the bank switching buttons (see the figure on page 258), to
select the bank.
3
Press the cross-point button to which the desired shot box is assigned.
This executes the shot box function.
269
Shotbox Execution