System Settings (System Config Menu) - Sony DVS-9000 User Manual

2
Note
Be sure to carry out this operation after reconfiguring the system, or after a
software upgrade.

System Settings (System Config Menu)

To make the system settings, use the System >System Config menu.
To display the System Config menu
In the Engineering Setup menu, select VF1 'System' and HF2 'System
Config.'
Note
After changing any of the following settings, be sure to press [Execute] to save
the new values. If you want to cancel the setting changes without saving them,
press [Clear].
Selecting the system operation mode
In the <Operation Mode> group of the System >System Config menu, select
one of the following.
Single Proc: Control mode in which the panel controls a switcher and up to
Single Simul: Control mode in which the panel controls a switcher and a DME
Note
Single Simul mode is disabled for a DVS-9000 system.
Dual Simul: Control mode in which the panel controls two switchers and the
274
Setup for the Whole System
This automatically checks all devices (excluding the DCU) connected to
the Data LAN.
Once switch to another menu, then display the Network Config menu
again.
Now the status area of the System >Network Config menu shows the
results of the automatic check.
two DMEs connected to the switcher.
connected to the switcher. The operating bank and DME are interlocked.
(See "System Setup" in Chapter 1 (Volume 1).)
DME connected to each switcher simultaneously.